If it doesn't hand tighten to 11 o'clock, the barrewl won't index with the gas tube, which is bad.īuilding a FAL isn't too hard with the basic tools and knowledge. Once you get the proper tools, you need to hand tighten the barrel to the receiver to about 11 o'clock. In order to do it right, you need to get the proper tools, which includes a FAL Barrel wrench and FAL Barrel Vise. I have done both and a FAL is a little more harder. I use leather, cloth or wood to protect the metal and it comes out undamaged but the tourq there is much less.īarreling a AR and Barreling a FAL is like comparing apples and Orangels. When you install an FAL barrel do they ever mate up so that they are past top dead center? in that I mean that if you tightened the barrel down it would be a few degrees past where it should be to get the proper torque spec? if so how do you correct that?Īlso can you place the gas block potrion of the barrel in a vise and use a receiver wrench to torque it down like you might an ar15? or would the 80-100ft/lbs of tourque possibly snap the gas block pins or distort the gas block? on ar's I always clamp the front sight base and torque the barrel that way.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |